Product Description
Completely plug and play wiring for MaxxECU Sport ECU, save the hassle of wiring on your own, just pull the stock ECU out, plug in and go.
Base setup comes ready to plug a MaxxECU Sport into your Gen3 with the following included:
- Sport ECU with expanded input / output capability via a ECU adapter box
- Plug and Play ECU adapter wiring
- Functional ABS, IMU data, functional dash, Power modes with e-throttle, Traction control, rolling launch control, adjustable 2 step launch control on the fly, cruise control, quick shifter, flex-fuel capable, etc. **(Lift Control not possible without adding a laser ride height sensor) **, adjustable engine braking not currently supported
- Bosch 4 channel ignitor
- Heat Sink for Ignitor
- Bosch LSU 4.2 wideband sensor for closed loop fuel control
INPUTS
Analog Inputs :
- TPS, Coolant, Intake Air Temp (all of the stock sensors)
- Gear Position Sensor (stock sensor)
- Quick shifter load cell (stock sensor) – over CAN
- Clutch switch
- Sidestand / kickstand safety input (this goes to the ECU directly on Gen3 Hayabusa) over CAN in the ecu adapter box
- Starter input / output (this goes to ECU directly on Gen3 Hayabusa) for 1 tap start just like stock
- (4) spare analog inputs for things like fuel pressure, oil pressure, wastegate pressure, laser ride height, etc.
Digital Inputs (2):
- Front Wheel Speed (both needed for traction control)
- Rear Wheel Speed (both needed for traction control)
- Flex Fuel Ethanol Content Sensor available over CAN if needed
OUTPUTS
- 6 Injector Outputs (Gen3 Busa will run upper injectors paired up 1&4 and 2&3 unless requested to use General Purpose Outputs for 8 injector full sequential
- 6 Ignition Outputs (4 outputs needed for coil ignitor), 2 spare 5v Outputs for NOS drivers, if not using NOS these are turned into ground outputs in the ECU adapter box.
- Ground Outputs (6 total):
- Starter
- Fuel Pump
- Fans
- 5 Spare ground outputs (shift solenoid output, shift light, boost control, etc.), 3 from GPO 1,2,3, and 2 from IGN5 & IGN6 repurposed from 5v outputs
- 12V Outputs (2 total):
- Electronic throttle
CAN
- CAN wired to CAN network which communicates with ABS, IMU, Dash, and additional CAN expansion module if purchased separately
ECU Adapter Box adds the follow inputs / outputs over CAN
- 3 Digital Inputs (1 is used by kickstand), can bring in ethanol sensor for flex fuel, buttons, switches, etc.
- 4 Analog Inputs (coolant, intake air temp, gear position, quick shifter load cell), this frees up room on the standard MaxxSport analog inputs
- 3 Ground Outputs (not to be used for precision control, but slower update rate required things like warning lights, auxiliary pump etc.
DATALOGGING
- Built in datalogging up to 1000 Hz sample rates
