Fuel System

Kawasaki OEM Carburator Holder for 33-40mm Lectrons KZ900-KZ1000-KZ1000J

The carb holders are for the 1973-1980 KZ900-1000 bikes, for use with 33 smooth bores or 36-38-40mm Mikuni carbs, or for use with Keihn Carbs.  They are available in sets of (4) or each.  Every carb holder comes with the 2 mounting screws...

Kawasaki OEM Carburator Holder Plug KZ900-KZ1000-J-GPz

These are the little rubber pieces that goes on the carb holders. Each carb holder requires one.  They sometimes crack and cause a rough idle situation, or a lean condition.

Kawasaki OEM Left Side Carburator Holder KZ900-KZ1000

This is the left side carburator holder for the 1976-1980 KZ900-KZ1000.  These fit the stock 26mm or 28mm carbs and the aftermarket 29mm Mikuni carbs only. If you have Mikuni Flat Slides, 34mm, 36mm, 38mm, or 40mm you will need to use the...

Kawasaki OEM Rear Tank Rubber Dampner KZ900-KZ1000

*Fits 1976-1977 KZ900, 1977-1981 KZ1000 Two of these dampers are required per bike.  They go over the frame rails.

Kawasaki OEM Right Side Carburator Holder KZ900-KZ1000

This is the right side carburator holder for the 1976-1980 KZ900-KZ1000.  These fit the stock 26mm or 28mm carbs and the aftermarket 29mm Mikuni carbs only. If you have Mikuni Flat Slides, 34mm, 36mm, 38mm, or 40mm you will need to use the...

Mikuni Radial Flat Slide Carburetors

Part# 001 The Mikuni RS Series Carburetors were designed and built in response to the needs of the world's top motorcycle road race and drag race teams. They required carburetors which could satisfy the precise fuel metering demands and high flow...