Product Description
Completely plug and play wiring for MAXX sport ECU, save the hassle of wiring on your own, just pull the stock ECU out, and put my wiring harness in and go
Base setup comes ready to plug a MAXX Sport into your GSXR-1000 with the following included:
– Sport ECU with expanded input / output capability via my ECU adapter box **Details at bottom of page under CAN **
– Plug and Play ECU adapter wiring
– Functional ABS, IMU data, functional dash, Power modes with e-throttle, Traction control, rolling launch control, quick shifter, flex-fuel capable, etc.
– Bosch 4 channel ignitor
– Bosch LSU 4.2 wideband sensor for closed looped fuel control
INPUTS
Analog Inputs :
– TPS, Coolant, Intake Air Temp (all of the stock sensors)
– Gear Position Sensor (stock sensor)
– Quick shifter load cell (stock sensor) – over CAN from my ECU adapter box
– Clutch switch
– Starter input / output (this goes to ECU directly on L7 GSXR-1000) for 1 tap start just like stock
– (6) spare analog inputs for things like fuel pressure, oil pressure, wastegate pressure, laser ride height, etc.
Digital Inputs (2):
– Front Wheel Speed (both needed for traction control)
– Rear Wheel Speed (both needed for traction control)
– Flexfuel Ethanol Content Sensor available over CAN
OUTPUTS
– 6 Injector Outputs (run upper injectors paired up 1&4 and 2&3 unless requested to use General Purpose Outputs for 8 injector full sequential
– 6 ignition outputs (4 outputs needed for coil ignitor), 2 spare 5v Outputs for NOS drivers, if not using NOS these are turned into ground outputs in the ECU adapter box.
Ground Outputs (6 total):
– Starter
– Fuel Pump
– Fans
– 4 Spare ground outputs (shift solenoid output, shift light, boost control, etc.), 3 from GPO 1,2,3, and 2 from IGN5 & IGN6 repurposed from 5v outputs
12V Outputs (2 total):
– Electronic throttle
CAN
– CAN wired to CAN network which communicates with ABS, IMU, and Dash
BoostBySmith ECU Adapter Box adds the follow inputs / outputs over CAN
– 3 digital inputs (left hand control mode buttons, Up/Down/Select)
– 4 analog inputs (coolant, intake air temp, gear position, quick shifter load cell), this frees up room on the standard MaxxSport analog inputs
– 1 ground output for Cooling fan relay control
DATALOGGING
– Built in datalogging up to 1000 Hz sample rates
